Controlling Sites in Batches¶
Fleet Control allows users to issue control commands through the batch control panel to control multiple sites in batches.
Prerequisites¶
Before starting, make sure the current account has been assigned the required asset permissions, operation permissions, and menu groups including Site Control. If not assigned, contact the application administrator.
Procedure¶
- Log in to EnOS Application Portal, and select Fleet Control in the application list.
- Select Site Control in the left navigation bar, and then select the target Site in the asset range filter.
- Click the Batch Control button
.
- A check box appears in front of the site list. Select the site that need to be controlled in batches, and click Control in the upper right conner of the list to bring up the batch control panel.
- Switch the device type tab, click Device List, check or uncheck the devices need to be controlled in the pop-up window, and click Confirm.
- Select the control commands in list form on the right side of the batch control panel to control devices configured with the selected control commands in sites.
- Select the target control command to perform the following operations.
- Telecontrol: Select the control value in the drop-down box, such as on-grid, off-grid, switch on, and switch off.
- Teleadjusting: Enter the control value in the input box, such as active power setting and reactive power setting.
- Click Execute to issue the control command.
Results¶
After control execution is complete, view the operation results through the pop-up window of batch control results.
- View the execution results of the control command on Control Result.
- Select View Details to view the device list for the corresponding result on the Execution Succeeded, Execution Failed, and In Progress tabs
- View the Control Object, Status, Control Point, Description, and other information about the target control command on the control detail panel.
If the operation result is Control Failed.
- Click the Retry button in the lower right corner of the pop-up window to retry the failed control commands.
- Do Retry in the control log. For more information, see Control Log.